Ultrasonic Wall Thickness Gauge TI-25LT

TI-25LT
Low Cost,
Ultrasonic Wall Thickness Gauge

Measuring Range
0.040 - 6.00 inches
1.00 - 150.0 mm

The new CHECK-LINE TI-25LT Wall Thickness Gauge accurately measures wall thickness and the extent-- from only one side!

Standard configuration: In its standard configuration, the TI-25LT is factory set to measure steel only.

Optional configuration: As a "no cost" option, the TI-25LT can be factory set to measure on any other single material instead of steel.

Easy upgrade to full TI-25M functionality (refer to separate data sheet). TI-25M measures on all metals, ceramics, glass and most rigid plastics. It provides Single Reading and Scan modes, where the probe is dragged over a large measuring area. The minimum reading recorded during the "scan" is displayed.

Upgrade to TI-25M requires factory installation of enhanced circuit board, new firmware and keypad.

Features of the TI-25LT ultrasonic thickness gauge:

Resolution of 0.004 inch (0.04 mm)

Large, backlit LCD display retains last reading

Simple operator controls virtually eliminate training

Special-purpose probes are offered for a variety of applications

Switch-selected units for inches or mm

For underwater surveying, probe cable lengths up to 50 feet are optionally

The TI-25LT probe is waterproof and can be submerged in water

The gauge is impact-resistant and environmentally sealed to provide trouble-free operation under the toughest field conditions

Typical Applications for a wall thickness gauge:

Applications for ultrasonic wall thickness gauge

Accessories for the TI-25LT:

Steel Test Blocks

Precision Machined and Finished
Includes NIST Report and Test Data
Includes Wooden Storage Box

Protective Holder

Constructed from heavy duty Cordura Nylon
Includes wrist & shoulder straps
Built-in belt loop

Specifications of the TI-25LT:

Range*

0.040-6.00" (1.00-150.0 mm)

Resolution

.004" (0.04mm)

Display

4½ - Digit, 0.5" Backlit LCD

Velocity Range

.0787-.3937 in/µs
(2000-10,000 m/sec)

Probe

1/4", 5 MHz, actual wearface is 5/8" (17mm)

Probe Wearface

PEEK (Polyethylethylkytone)

Cable

4ft. (1.2m) waterproof cable with non-polarized, quick-disconnect connectors. Op

Temp. Limits

Ambient: -20 to 120° F (-30 to 50° C)
Material: 0 to 200° F (-20 to 100° C) Special high temperature probes are optionally available

Battery Type

Two AA batteries

Battery Life

200 hours

Weight

710 ounces (280g)

Dimensions

2.5 x 4..5 x 1.25"
(64 x 114 x 32mm)

Accessories

Probe/cable assembly, 4 oz. bottle of coupling fluid, NIST Calibration Certificate, 2 AA batteries, operating instructions, hard-plastic carrying case.

Warranty

Gauge: 5 Years
Probes: 90 Days

Measuring Limits

Complete Kit

Complete Kit includes: Gauge, probe, 4 oz. bottle of coupling fluid, 2 AA batteries, NIST Calibration Certificate and Operating Instruction Manual - all in a foam-fitted carrying case.

TI-25LT Low Cost, Ultrasonic Wall Thickness Gauge